kNm Hydraulikk offer courses in flange work acording to NS-EN 1591-4 (formerly known as Norwegian Oil and Gas and OLF Guideline 118). The course provides knowledge in preparation, planning, execution, and documentation of work on bolt tensioning of flange connections on pressurized systems.
Executive personnel test their skills under controlled conditions and professional training. The course contains a combination of theory and practice. Courses are conducted at our premises in Sola, just outside of Stavanger. The duration of the course is four days.
For more information and to sign up for our courses please see course overview.
SAFE WORKING WITH FLANGES
OLF started the Gas Leakage Project in 2003 to reduce the number of leaks on the Norwegian Continental Shelf. Causal analysis showed that approximately 75% of all hydrocarbon leaks were due to human failure.
Since 2003, the project has contributed significantly to reducing the number of gas leaks on the Norwegian Continental Shelf.
MODULE-BASED TRAINING NS-EN 1591-4
kNm Hydraulikk offer module-based training of personnel following the NS-EN 1591-4 standard. This standard deals with the qualification of the competency of personnel who assemble screw connections on pressurized systems in critical applications.
The course also includes additions that apply to company-related requirements and procedures.
VALIDITY & PLACE
The course is held at Sola located only 5 minutes from the airport.
The course has a validity of 5 years under the following conditions:
The executing skilled worker has worked continuously on flange connections and pressurized systems over the last 6 months.
There is no basis for questioning the competency of the performing skilled.
After 5 years, the skilled worker must take a rehearsal course to renew the certificate.
Our employees have experience in the following areas:
Technical Sales
The employees at kNm Hydraulikk are committed to delivering fast, accurate and safe solutions to our customers. We specialize in developing tailor-made solutions for our clients.
Design & Planning
Some applications are more challenging than others. For example, there may be access problems with standard equipment. In such cases, the R&D department at kNm Hydraulikk can help you with tailor-made solutions.
Engineering Services
kNm Hydraulikk have advisors that can assist in the calculation of bolted connections as well as the methods one should use.
Calibration
All torque tools need to undergo periodic calibration to ensure optimal performance. kNm Hydraulikk calibrates tools according to current standards.
Enerpac Services
kNm Hydraulikk is an authorized Enerpac Service Center. We maintain our status through a regulated review process conducted by Enerpac.
Bolting
Bolt tightening with the right equipment and torque prevents future leaks in flanges and mechanical connections. The right torque is crucial for optimal results.
Courses
kNm Hydraulikk offer courses in flange work acording to NS-EN 1591-4 (formerly known as Norwegian Oil and Gas and OLF Guideline 118). The course provides knowledge in preparation, planning, execution, and documentation of work on bolt tensioning of flange connections on pressurized systems.